OBDSTAR nowadays released a new professional key programmer for Ford or Mazda cars. Today, obdstartool engineers tested on Mazda 6 2013 to add smart key lost.
Device to use:
Two keys to be programmed
OBDSTAR F100 key programmer for Mazda/ Ford
OBDSTAR F100 is professional for programming Auto Keys and Smart Keys for Mazda/Ford. All operations completed are required without password needed.
Model:
Mazda 6 2013
Steps to program Mazda 6 smart keys:
Connect F100 key tool to the car
Then F100 starts; it is with Mazda software v30.15
Loading…
Initializing…
Select Atenza
Then With Smart
Connecting…
Switch ignition on
Put all the key out of the car 1 meter away
Communication…
Press and hold the vehicle start button for 10 seconds, Start the button indicator li…
Select Add smart key lost
Instruction:
All samrt keys should be erased; MIN keys are required; Press ENTER to continue, press ESC to return
Switch ignition on
Communication…
Current number of key smart: 2; Press ENTER to continue, press ESC to return
Configuring the system,please wait…
Reading vehicle information…
Ignition switch status is open? Press ESC
Again, press and hold the vehicle start button for 10 seconds; start the button indicator light deom green to yellow; press the start button again; instument to open…
Configuring the system,please wait…
Current number of keys: 0
Erase complete
Take back the two keys
OBDSTAR F100 Ford programmer is configuring the system,please wait…
Switch ignition off
Configuring the system,please wait…
Switch ignition on
Use a new smart key to contact start button for a while until configuration complete, press ENTER to continue
Configuring the system,please wait…
Current number of keys: 1
Program success!
Same way to program another:
Switch ignition off
Configuring the system,please wait…
Switch ignition on
Use a new smart key to contact start button for a while until configuration complete, press ENTER to continue
Current number of keys: 2
Program success! Press ESC to return
You have completed the following procedures, engine can be started:
1- switch ignition off
2- put on the brakes, the key 1 press start button to start the engine for 3 seconds, then turn off the ignition switch
3- if you want to add more keys, please repeat procedure 2, complete
Finally, test the new keys to check they can work
